|
| Details for Tool Caddy Plans
 Free Tool Caddy plans - This is a very simple project when pre-cut pieces are used. The handle is made from a 1/2 inch dowel, the bottom from 1/4 inch masonite board, and the rest from 3/4 inch pine planking scraps. Use the diagrams to cut out all pieces to the specified sizes. Using a router, radial arm saw, or table saw; cut a 1/4 inch wide - 1/4 inch deep groove into the inner sides of both sides and both ends 1/4 inch from the bottom edges. Drill the 1/2 inch deep 1/2 inch diameter holes into the inner side of both ends near the top as shown in the drawings.
Now all your Junior Woodcrafter needs is these six parts, ten 1-1/2 finishing nails (two for spares), a hammer, some wood glue, one sheet of 150 grit sandpaper, a really cool workshop apron small enough for kids, and safety goggles.
|
|
