A panel-saw table can be used with a lot more than just a panel saw. Use these instructions to see how -- with the help of a plunge router -- the table can be used to create faux raised-panel cuts.
Stone Pedestals can add a flair (and height) to any show piece, indoors or out. But they can be expensive and heavy. This plan allows your to use plywood to create a pedestal that looks like stone.
This hardly counts as the SuperStation's first project, but I wanted to report on it just because it was a first of using the Incra TS III with both the table saw and the new Rout-R-Lift...
Do you have a plan for making feather boards? I want to know what kind of wood to use, and how to cut the fingers so they're springy enough to hold my stock and prevent kickback, too.
A featherboard applies pressure to the edge of a board while it is being run through a machine. Host David Thiel explains how to make a featherboard for the saw and router.
A featherboard is a very useful tool when cutting thin stock on a table saw or router table, and is quite easy to make. Every woodworker should make and keep a few on hand.
